Installation steps for re selected spiral chute

Installation steps for re selected spiral chute

Introduction to Installation Step 1 of Gravity Separation Spiral Chute Gravity beneficiation is widely used in the beneficiation of metallic and non-metallic ores due to its low pollution and low cost. Fiberglass reinforced plastic chute is one of the gravity separation equipment, with a structural feature that the cross-section presents a cubic parabolic state, suitable for processing finer particle sizes of -0.2MM. During the selection process, do not add water for flushing, and divide the chute into sections at the end to select fine, medium, and tailings. 2、 Working principle: The spiral ore separator does not need to be limited to stacking on the cross (or tripod) of the support table. The same mortar is slowly fed onto the spiral groove surface through the feeding chute installed at the beginning of the rotating groove, and selected for operation. The bottom is equipped with a valve block type equipment cutting groove, which divides the sorted products into three (or four) categories according to grade along the radial direction. Change the selection width of each equipment by adjusting the orientation of the valve block. The product gathering bucket is a concentric circular tube that enables the diverse mineral flows obtained to converge and export differently. The transverse plane of the fiberglass spiral chute and the slope of the curve change, making it particularly suitable for the selection of small particle materials. Gravity concentration spiral chute installation step 3. Features This equipment can be used to separate iron, ferrotitanium, ferrochrome, ferrosulfide, zircon ore, Rutile ore, monazite ore, phosphate rock, tungsten, tin ore, tantalite ore, niobium, and other non-ferrous metal ores, rare mineral metals and non-metallic minerals with different gravity. This machine has the advantages of stable and easy control in the selection process, allowing for a wide range of ore concentration, high enrichment ratio, high recycling rate, small land occupation, low water consumption, simple structure, no need for power, large processing output, simplified installation, simple operation, low investment, and fast efficiency. Installation steps of gravity concentration spiral chute IV. The chute can be divided into three categories according to the Granularity of the processed ore materials: (1) coarse spiral chute. The maximum particle size of feed is more than 2-3mm, and the maximum can reach 100-200MM. (2) Mineral sand chute, processing 2-3 millimeter sized ore. (3) Slime spiral chute, feeding Granularity<0.074mm. 5、 Applicable fields The application scope of spiral concentrator is to separate fine grained iron ore, Ilmenite, Chromite, pyrite, tin ore, tantalum niobium ore, placer gold ore, coal mine, monazite ore, Rutile ore, zircon, rare earth ore and other metal and non nonferrous metal minerals with sufficient density and specific gravity difference. Installation steps for re selection spiral chute Installation steps for re selection spiral chute

Installation steps for re selected spiral chute