Working Principle Video of Spiral 90 Chute

Working Principle Video of Spiral 90 Chute

The working principle of the spiral 90 chute video 1 explains that the chute sorting of minerals includes an inclined flow sorting process. The slurry is fed to a inclined chute or slope, and under the push of water flow, the ore particles are loose and layered. The upper layer is so light that the minerals are quickly discharged to the outside of the chute, while the lower part, which is heavier than the main minerals, stagnates in the inner groove or slowly discharges from the lower part. After being obtained, the concentrate and tailings can be obtained. The spiral concentrator is a machine for mining and beneficiation, especially ideal for mineral mining on coasts, riverbanks, sandbanks, and river beds. The product has the characteristics of reasonable structure, simple installation, small footprint, simple operability, stable beneficiation, clear screening of minerals, strong processing capacity, high efficiency, ultra-high enrichment ratio, high recovery rate, and stable operation. There are also advantages such as lightweight, moisture prevention, rust prevention, corrosion prevention, and strong applicability to fluctuations in ore feed volume, concentration, particle size, and grade. 2、 The production principle is that the slurry is evenly distributed and slowly fed onto the surface of the spiral groove through the feeding chute installed on the rotating groove head, implementing sorting. The bottom of the rotating groove is equipped with a valve block type product selection groove, which divides the selection equipment into three types according to grade along the radial direction. By adjusting the position of the valve block to change the cutting width of each product, the equipment gathering hopper allows for the differentiation and aggregation of the obtained variable mineral flow. The cross-section of the spiral chute and the slope change of the curve are very suitable for the selection of fine particle materials. Working Principle Video of Spiral 90 Chute 3. Characteristic FRP spiral chute has attracted more attention among many gravity separation machines due to its low power consumption, simple structure, small area occupation, simple operation, stable beneficiation, clear beneficiation, no moving parts, convenient Computerized maintenance management system, large processing capacity per unit area, etc. The machine has a wide and relatively stable groove surface, and the mortar has a large area of laminar flow, which is more suitable for processing ores with medium and fine (-4mm) Granularity. Glass fiber reinforced plastic chutes with diameters of 400, 600, 900, and 1200MM have been manufactured domestically, Ф The production capacity of 1200mm four heads is about 4-6 tons/hour. Working principle video of spiral 90 chute IV. The chutes can be divided into three categories according to the Granularity of the processed ore materials: (1) Coarse grained chutes. The maximum Granularity of the feed is more than 2-3 mm, and the maximum can be 100-200 mm. (2) The ore chute is used to handle 2-3 millimeter sized ore materials. (3) Slurry chute, with a feeding particle size less than 0.074MM. 5、 This machine is used to separate 0.3-0.02mm fine materials to obtain iron, ferrotitanium, ferrochrome, ferrosulfur, zircon ore, Rutile ore, monazite ore, phosphorus, tungsten sand, tin ore, tantalum niobium, niobium ore and other non-ferrous metal ores, rare mineral metals and non gold minerals with gravity difference. Video on the Working Principle of Spiral 90 Chute Video on the Working Principle of Spiral 90 Chute

Working Principle Video of Spiral 90 Chute